Settings problem

Hello , my name is Davide and I'm trying to configure Jedicut with this board :
5 Axis control board JK05-K6

From board's the manual I read that the parallel port settings should be :

Pin 1 : all A, B, X, Y, Z axis enable input
Pin 2 : X pulse
Pin 3 : X direction
Pin 4 : Y direction
Pin 5 : Z direction
Pin 6 : A pulse
Pin 7 : A direction
Pin 8 : B pulse
Pin 9 : B direction
Pin 10: X limit
Pin 11: Y limit
Pin 12: Z limit
Pin 13: A limit
Pin 14: Relay input (spindle)
Pin 15: ESTOP
Pin 16: Y pulse
Pin 17: X pulse
Pin 18/25: GND

Now, since I have no idea on how to change the parallel cable pins, there is a way in Jedicut to assign the correct pins to the motors that requires pin 16 and 17 for direction?

Thanks
Davide